technical data sheet 1 / 5 straight male receptacle pin in paste r222.940.300 limited detent-tape and reel by 500 series : smp-com issue : 1121 c in the effort to improve our products, we reserve t he right to make changes judged to be necessary. all dimensions are in mm. . . pn ao components body center contact outer contact insulator gasket others parts - - materials brass brass - peek - - - - plating ( m m ) npgr npgr - - - -
technical data sheet 2 / 5 straight male receptacle pin in paste r222.940.300 limited detent-tape and reel by 500 series : smp-com issue : 1121 c in the effort to improve our products, we reserve t he right to make changes judged to be necessary. packaging specification standard un it other 500 contact us electrical characteristics environmental impedance 50 w operating temperature - 55/+125 c frequency 0 - 12.4* ghz hermetic seal na atm.cm3/s vswr 1.1** + 0,0000 x f(ghz) maxi panel leakage na insertion loss 0.12 ? f(ghz) db maxi rf leakage - ( n a - f(ghz)) db maxi voltage rating 335 veff maxi dielectric withstanding voltage 500 veff mini insulation resistance 5000 m w mini other characteristics assembly instruction na others : * ros 1.35 at 12.4ghz mechanical characteristics **ros at 6ghz center contact retention axial force C mating end 6.8 n mini axial force C opposite end 6.8 n mini torque na n.cm mini recommended torque mating na n.cm panel nut na n.cm mating life 100 cycles mini weight 0,3610 g
technical data sheet 3 / 5 straight male receptacle pin in paste r222.940.300 limited detent-tape and reel by 500 series : smp-com issue : 1121 c in the effort to improve our products, we reserve t he right to make changes judged to be necessary. solder procedure 1. deposit solder paste snag4cu0.5 on mounting zone by screen printing application. we recommend a low residue flux. we advise a thickness of 150 micromm ( 5.850 microi nch ). verify that the edges of the zone are clean. 2. placement of the receptacle on the mounting zone wi th an automatic machine of pick and place type. a video camera is recommended for posi tioning of the component . adhesive agents must not be used on the receptacle. 3. this process of soldering has been tested with conv ection oven .below please find ,the typical profile to use. 4. the cleaning of printed circuit boards is not oblig ed . 5. verification of solder joints and position of the c omponent by visual inspection. temperature profile parameter value unit temperature rising area 1 - 4 c/sec max peak temperature 260 c max dwell time @260c 10 sec min dwell time @235c 20 sec max dwell time @235c 60 sec temperature drop in cooling area -1 to - 4 c/sec max dwell time above 100c 420 sec
technical data sheet 4 / 5 straight male receptacle pin in paste r222.940.300 limited detent-tape and reel by 500 series : smp-com issue : 1121 c in the effort to improve our products, we reserve t he right to make changes judged to be necessary. coplanar line pattern and signal are on the same side. thickness of pcb : 1.6mm the material of pcb is the epoxy resin of glass fabrics bacs (er:4.8). the solder resist should be printed exept for the land pattern on the pcb.
technical data sheet 5 / 5 straight male receptacle pin in paste r222.940.300 limited detent-tape and reel by 500 series : smp-com issue : 1121 c in the effort to improve our products, we reserve t he right to make changes judged to be necessary.
|
